|
Fish University 102: How to estimate a fish's weight |
The short measurement is the distance in inches from the tip of the lower jaw to the inner fork of the tail, whereas the "Long measurement" is the overall length of the fish. The bill and tail are both added length that cannot be relied upon for estimating weight so scientists use the lower jaw as a way to be more accurate. Just like some
humans are taller than others, fish are the same. Sometimes
a very long fish has little girth, and sometimes an extremely wide fish is relatively
short. Generally speaking, to make the
magical 1,000 pound mark, a fish needs to have at least 72 inches of girth (6 feet) and
156 inches in length using the short measurement (13 feet).
Once you have
the information you need, simply plug it into the following formula and you should be able
to calculate a fishs weight within ten percent: (G2
x S)/800 G=girth in
inches (measured all the way around the fattest part note: if you can only measure
the fish on one side, simply take the full measurement from top to bottom and double it) S=short
measurement in inches
Using the
measurements above to make a thousand pounds, the formula goes like this: 72 x 72 x 156 =
808,704 808,704/800 =
1010.88 Another Way to Estimate: And here's another way to measure Blue Marlin that's a bit simpler and sometimes more accurate. Simply take the measurement around the ankle of the fish just ahead of the tail. 12" will be a 200 pound fish, and for each extra inch, add 100 pounds. To make that magical "grander" mark, the ankle will be about 20 inches.Using these two techniques together will greatly enhance
your ability to guesstimate the weight of a fish. Of course, the second method only works
for larger Marlin, so use them as a guide. It's not
usually something you think of bringing fishing, but next time you go you may want to toss
your calculator and a printout of these calculations into your bag just in case. If
you have any questions, please e-mail us. |